P140E

110008 - P140E

Information saved in
DME

Fault code
110008 - P140E

Fault text
Cylinder injection cutout: tank fill level too low

Fault description
The diagnostic function monitors whether the diagnostic
fault codes 0x110001 or 0x110002 have been recognized
while the lambda control also reaches a specific deviation.

Condition for fault identification
Test condition:
The fault is recognized when the fault 0x110001 or
0x110002 is recognized and the lambda control rises above
a value defined in the program map.
Potential problem source(s):
- Tank fuel level too low
- Collateral fault
Terminal condition: none
Voltage condition:
- None
Temperature condition:
- Precatalyst temperature > 500 °C
Time condition:
- None
Other conditions:
- Engine on

Condition for fault memory entry
This fault is logged in the control module's fault memory if
it remains present for longer than 1.2 sec.

Action in service
- No additional action, as this fault is also caused by an
empty tank or other faults

Fault effect and breakdown warning
Breakdown notice:
- Check fuel level
Possible apparent symptoms:
- Power reduction from cylinder deactivation

Driver information
Warning light:
- ECE emissions warning lamp: off
- US emissions warning lamp: on
- ECE electronic engine power reduction: off
- US electronic engine power reduction: off
- CC message: on

Service instruction
- The fuel injection is deactivated to protect the catalytic
converter