00 00 610 Service - Engine Oil (N63)

00 00 610 - Service - engine oil (N63)





Special tools required:
- 11 9 240 11 9 240 Oil Filter Wrench





The FRU item 00 00 610 comprises the engine oil service incl. supplementary service.

Only the engine oil service will be described in these repair instructions.

The supplementary service is made up of the following operations which must be taken from the relevant repair instructions:

- Carry out function check on parking brake Component Tests and General Diagnostics
- Reset service interval indicator according to factory specification





Important!
Perform engine oil service only when engine is at normal operating temperature (>70 °C engine oil temperature).

Observe the exact engine oil filling capacity.

Overfilling the engine with engine oil will result in engine damage.

Inspection and drain-off times must be observed.





Warning!
Danger of scalding!

Carry out work on the vehicle only when wearing oil- and heat-resistant protective gloves incl. forearm protection, face guard and protective apron.





Recycling:
Catch and dispose of drained engine oil in a suitable container.

Observe country-specific waste-disposal regulations.





Release screw (4) on underbody panelling.

Expose service opening (2) for oil filter cap with aid of designated holes (3).

Release screw (5) on underbody panelling.

Expose service opening (1) for oil sump screw plug with aid of designated holes (3).





Note:
For purposes of clarity, the graphic shows the underbody panelling and underbody protection removed.

Release screw plug (1) of oil filter cap (2) with a suitable tool and drain engine oil.

Tightening torque 11 42 2AZ 11 42 Oil Filter and Pipes.

Remove screw plug (3) from oil sump and drain engine oil.

Tightening torque 11 13 1AZ Mechanical Specifications

Installation Note:
Replace sealing rings.





Release oil filter cap (1) with special tool 11 9 240 11 9 240 Oil Filter Wrench

Tightening torque 11 42 1AZ 11 42 Oil Filter and Pipes.





Remove and insert oil filter element (3) in direction of arrow.

Installation Note:
Oil filter element (3) must snap audibly into oil filter cap (1).

Installation Note:
Replace oil filter element (3) and sealing ring (2).

Note:
Moisten sealing ring (2) with engine oil.

Assemble engine.

Pour in engine oil Capacity Specifications.

Note:
Start engine and run at idle until oil pressure warning lamp goes out.

Turn off engine.

Check oil filter cap and screw plugs (1 and 2) for oil filter cap and oil sump for leaks.





Checking engine oil level:

- Park vehicle on a horizontal surface
- Allow engine at normal operating temperature to run for three minutes with increased revs (approx. 1100 rpm)
- Read off engine oil level in instrument cluster or on Control Display
- Top up engine oil if necessary