Sunroof / Moonroof: Adjustments

54 12 003 Adjusting Glass Slide/Tilt Sunroof Cover

Special tools required:







Close glass slide/tilt sunroof cover (zero position).

Ideal setting:







- Distance:
- Distance (A) between lid and roof at front and rear must be the same.
- Insert special tool 00 9 341 between gasket and cover. This check (sliding in and pulling out the special tool) must be subject to tightness

- Height:
- Front - flush to 1 mm deeper
- Rear - flush to 1 mm higher

Adjusting the glass slide/tilt sunroof cover:







Remove gaiter on left and right.
Close glass slide/tilt sunroof cover again (zero position).
Slacken screws (1) on left/right little by little.
Until glass slide/tilt sunroof cover (2) can still just be moved.

Height adjustment:







Adjust height of glass slide/tilt sunroof cover (1) to roof (2) using special tool 00 9 315 (gap dimension wedge).
Press glass slide/tilt sunroof cover at front and rear up or down until ideal position is reached.







Distance setting:
Slide glass slide/tilt sunroof cover towards front/rear until ideal position is obtained.

When the ideal setting is reached:







- Tighten screws (1)
Tightening torque: 54 12 2AZ.

- Check function and adjustment of glass slide/tilt sunroof cover (2).
- Carry out initialisation