54 12 336 Removing and Installing/Renewing Guide Element Pair For Glass Slide/Tilt Sunroof

54 12 336 Removing And Installing/Renewing Guide Element Pair For Glass Slide/Tilt Sunroof







Necessary preliminary work:
- Remove glass slide/tilt sunroof cover







NOTE: Initiate manual movements of guide element via the drives using an offset Allen key.







Installation note:
- Microencapsulated screws (Loctite) must be replaced and may not be reused
- Screw connection must be completed within 20 minutes (start of hardening)
- Microencapsulated screws must not be retightened
- Clean thread of nut beforehand in event of repeated use







Release screws (1) on left and right.

Installation note:
Replace screw (1).

Tightening torque 54 12 04AZ.







Move guide element (1) back until garage is exposed.







Lever out garage stop (1) with plastic wedge.







Move guide element (1) up to recess (2).







Lever control lever (1) out of guide rail and turn.







Installation note:
Spacer (1) of control lever must be situated in guide channel.







Remove control lever from guide element.







Grip lid guide element (1) at bolt.
Move drive carriage (2) towards rear until recess in lid guide element is reached.







Reposition lid guide element (1) and remove from drive cable carriage.







Installation note:
Assemble glass slide/tilt sunroof and carry out function check.
Initialise glass slide/tilt sunroof.