72 12 000 Removing and Installing/Replacing Airbag Module on Passenger Side

72 12 000 Removing And Installing Or Replacing Airbag Module On Front Passenger Side







IMPORTANT:
Operations on pyrotechnical devices may only be carried out by authorised experts.
Improper, unauthorised operations may result in serious dangers.
Unauthorised persons are strictly prohibited from performing any operations on this system.







WARNING:
Read and comply with safety instructions for handling airbag modules and pyrotechnical belt tensioners.
Incorrect handling can lead to airbag deployment and cause injury.
A damaged airbag must be replaced because its protective function is compromised or, in an extreme situation, it can no longer execute its protective function.







Installation note:
- Microencapsulated screws (Loctite) must be replaced and may not be reused
- Screw connection must be completed within 20 minutes (start of curing)
- Microencapsulated screws must not be retightened
- Clean thread of nut beforehand in event of repeated use







Necessary preliminary work:
- Disconnect battery earth lead
- Remove glove box with housing







Release screws from holder.

NOTE: The holder does not have to be removed to access the front screws on the airbag module.







Unfasten plug connection (2) and disconnect.
Release screw (1).
Swing control unit out of rubber mount and feed out.







Unlock plug connection (1) and disconnect.







Release all screws on airbag module.
9 Schrauben = F01, F02, F03, F04, F07, F18
14 Schrauben = F10, F11

Installation note:
Replace screws.
Tightening torque 72 12 01AZ.
Remove airbag module from dashboard.