32 00 620 Adjusting Rear Axle
32 00 620 Adjusting rear axle
Important!
Altered procedure from previous axle alignment!
Turning the adjusting screw on the swinging arm or on the wishbone always results in a camber and toe change!
Separate camber or toe adjustment is no longer possible!
Specific camber and toe adjustment is only possible with the aid of the following diagram!
Note:
Vehicles with ACC only:
- After an adjustment of the rear axle which alters the driving axle, check adjustment of ACC sensor
Vehicles with rear axle slip angle control only:
- Carry out adjustment of rear axle only with aid of BMW Diagnosis and Information System
Procedure, lane / camber adjustment (in design position)
Unit of measurement in diagram: [min]
Description using the example value entered at the top of the diagram:
1. Read off actual value (1) for toe/camber on wheel/axle alignment analyzer and enter in diagram
(in example: toe --15', camber --90')
2. Drag parallel line to "Wishbone" line (C) through entered actual value (1)
3. Point of intersection (2) on "Swinging arm" line (D) produces toe/camber intermediate adjustment value
(in example: toe -4�, camber -108�)
4. Adjust intermediate adjustment value (2) by turning adjusting screw on wishbone
- Refer to operation described below "Adjusting on wishbone"
5. Adjust nominal value (3) for toe/camber by turning adjusting screw on swinging arm (toe/camber value moves on line (D))
- Refer to operation described below "Adjusting on swinging arm"
Procedure, toe / camber adjustment for ride-height-dependent measurement (unloaded):
Unit of measurement in diagram: [min]
Description of adjustment using the diagram (ride-height-dependent measurement/ unladen)
1. Read off nominal value (3) at wheel/axle analyzer and enter in diagram (in example: toe +12�/ camber -78�)
2. Move lines (D) and (C) in parallel so that the point of intersection of the two lines (D1 and C1) is the entered nominal value
3. Read off actual value (1) for toe/camber on wheel/axle alignment analyzer and enter in diagram
4. Further procedure as when adjusting in design position:
- Drag parallel line to "Wishbone" line (C 1) through entered actual value
- Point of intersection on "Swinging arm" line (D1) produces toe/camber intermediate adjustment value
- Adjust intermediate adjustment value by turning adjusting screw on wishbone
^ Refer to operation described below "Adjusting on wishbone"
- Adjust nominal value (1) for toe/camber by turning adjusting screw on swinging arm (toe/camber value moves on line D1)
^ Refer to operation described below "Adjusting on swinging arm"
Adjusting on wishbone:
Replace nut (1) prior to adjustment and join to 5 Nm.
Turn eccentric screw (2) until intermediate adjustment value is obtained.
Tighten nut (1).
Tightening torque 33 32 7AZ.
Adjusting on swinging arm:
Replace nut (1) prior to adjustment and join to 5 Nm.
Turn eccentric bolt (2) to adjust nominal value.
Tighten nut (1).
Tightening torque 33 32 2AZ.
Diagram dependence toe / camber adjustment (for printing and entering values):
v �4v :
