Engine Oil Service

11 00 ... Service - Engine Oil (S65)







WARNING:
Risk of scalding.
Carry out work on the vehicle only when wearing oil- and heat-resistant protective gloves incl. forearm protection, face guard and protective apron.







IMPORTANT:
Perform engine oil service only when engine is at normal operating temperature (greater than 70 °C engine oil temperature).
An exact engine oil level is only determined with the engine oil temperature ≥ 70 °C.
The engine oil temperature can be read out on the instrument cluster.
Observe the exact engine oil filling capacity.
Overfilling the engine with engine oil will result in engine damage.
INSPECTION and drip-off times must be observed.
Oil level determination via on-board computer button will only detect changes of greater than +/- 0.5 litres.







Recycling:
Catch and dispose of drained engine oil in a suitable collecting vessel.
Observe country-specific waste disposal regulations.







Pull off anti-twist lock (2).

Installation note:
Arrow (1) must point to the sensor for the intake air temperature.







WARNING: Risk of scalding.

NOTE: The remaining engine oil cannot drain into the oil sump until the oil filter cover has been released.

Release oil filter cap (1).
Tightening torque 11 42 1AZ.

Installation note:
Replace oil filter element and sealing rings.







WARNING:
Risk of scalding.
Carry out work on the vehicle only when wearing oil- and heat-resistant protective gloves incl. forearm protection, face guard and protective apron.

Loosen screw plug (1) with nut and a long extension (2).







Tilt long extension (1) with nut and screw plug in direction of arrow.

Recycling:
Catch and dispose of engine oil with suitable equipment.







Remove oil drain plug (1).
Compliance with a drip-off time of 10 minutes is absolutely mandatory.
Remove oil drain plug (2).
Compliance with a drip-off time of 2 minutes is absolutely mandatory.
Tightening torque 11 13 1AZ.

Installation note:
Replace sealing ring.

Assemble engine.
Pour in engine oil.







Checking engine oil level:
- Park vehicle on a horizontal surface
- Start engine and run at idle speed until engine oil temperature reaches ≥ 70 °C.
- Press the on-board computer button for more than 3 seconds to determine the oil level again.
- Only changes of greater than +/- 0.5 litres will thereby be detected.
- If necessary, carry out a distance reset.
- Top up engine oil if necessary
- Pre-delivery check / engine replacement







Carry out distance reset by only using the diagnosis system.
Comply with vehicle specific maintenance specifications.