Manifold Pressure/Vacuum Sensor: Service and Repair

13 62 010 Removing And Installing/Replacing Differential Pressure Sensor (N52T)







IMPORTANT: Read and comply with notes on protection against electrostatic discharge (ESD protection).







Necessary preliminary work:
- Remove acoustic cover







Unclip wiring harness (1) and lay to one side.
Unlock connector (2) and remove.
Release screws (3).
Tightening torque 13 62 4AZ.
Pull differential pressure sensor (4) out of intake plenum.







Installation note:
Read out fault memory of control unit of Digital Motor Electronics (DME).
Check stored fault message.
Delete fault memory.