52 26 412 Replacing Backrest Cover For Right Rear Seat

52 26 412 Replacing Backrest Cover For Right Rear Seat

Special tools required:







Necessary preliminary work:
- Remove backrest for rear seat
- Remove guide sleeves







Depending on equipment specification:
Ohne SA 413: Unclip cover (1) for combined roller cover mount.
Mit SA 413: Unclip trim cover for combined roller cover mount.







With option SA 413:
Release screws (1).
Tightening torque 52 26 09AZ.
Remove mount for combined roller cover.







Gently slide lock trim (1) on side edge of backrest downwards and unclip to one side.
Gently slide lock trim on rear side towards middle.
Unclip and remove lock trim.







Installation note:
Retaining lugs on trim must not be damaged.
If necessary, replace faulty cover.







IMPORTANT: Risk of damage.

Insert plastic wedge from outside between trim (1) and lock.
Carefully lever outer side of trim (1) with plastic wedge upwards out of catch.
Lever inner side of trim (1) with plastic wedge out of catch.
Remove trim upwards.







Release screw (1).
Tightening torque 52 26 02AZ.
Remove outer mount (2).







Lever out welt in marked area from backrest frame.
Remove backrest cover with padding from backrest frame.







Detaching cover and upholstery:
- Release all retainers in marked area
- Remove cover from upholstery
- Remove all remnants of retainers from cover and padding







Installation note:
Insert new clamp (2) with special tool 52 0 050 and bend closed.







Replacing cover:
- Pull all trim wires out of cover
- If necessary, cut pockets in new cover for trim wires
- Push trim wires into cover pockets