31 12 003 Removing and Installing/Replacing Top Right Wishbone

31 12 003 Removing and installing / replacing top right wishbone







NOTE:
Control arms with + or - marking (see illustration) are camber correction arms:
- Underdimension variant
+ Overdimension variant

These camber correction arms are used to correct the camber values by 30 minutes.
To be used only if the tolerance values are exceeded or undershot.
An unmarked wishbone is a standard part.







Necessary preliminary tasks:
- Remove partition wall for the right units compartment.
- Remove right wheel arch cover (rear part).







Release screws (1).
Remove auxiliary part (2).

Installation note:
When installing, make wiring harness penetration (3) is in correct position.







The subsequent procedure is described in the document "Remove/install/replace wishbone at the top left".