Variable Valve Timing Solenoid: Service and Repair

11 36 655 Removing and installing/replacing both solenoid valves (N55)





Important!
On removing and installing the VANOS solenoid valve (intake) and VANOS solenoid valve (exhaust), adhere to conditions of absolute cleanliness.
Possible malfunction if there is dirt contamination in the valves:
^ Irregular operation
^ OBD fault entry
^ Exhaust gas emission characteristics.
^ Low engine performance





Necessary preliminary work:
^ Remove ignition coil cover





Disconnect plug connection (1) on VANOS intake solenoid valve.

Disconnect plug connection (2) on VANOS exhaust solenoid valve.





Release screw (2).

Remove VANOS intake solenoid valve (1) with holder towards the front.

Release screw (3).

Move VANOS exhaust solenoid valve (4) with holder approx. 10 millimeters towards the front

Tightening torque 11 36 3AZ.





Turn the VANOS exhaust solenoid valve (1) approx. 90° in direction of arrow until it can be removed from the front on engine wiring harness.





Remove O-ring (2).

Remove support ring (1).

Installation Note:
Replace support and O-rings.





Assemble engine.

Check function of Digital Engine Electronics.