Alternator: Service and Repair

12 31 020 Removing And Installing Or Replacing Alternator (N63)







Necessary preliminary tasks:
- Turn off ignition
- Disconnect battery negative lead
- Remove acoustic cover
- Remove intake filter housing
- Remove fan cowl with electric fan
- Remove alternator drive belt
- Remove intercooler expansion tank.
- Remove fuel feed line







IMPORTANT:
Risk of damage.
Cover radiator.







Release clamps (1) and (2).
Replace clamps (2).
Detach both charge-air ducts (3) and remove.
Check gaskets on turbocharger, replacing if necessary.







Picture shows the left side, the procedure for the right side is identical.
Detach hoses (1) from clean-air pipe. Release screw (2).
Tightening torque 13 71 1AZ.
Detach clean-air pipe (3) in direction of travel from turbocharger.
Check seals on clean-air pipe, replacing if necessary.







Pull off cable duct (1) from cable holder (2) in upward direction.
Release cable (3) from holder.







Pull off plug (1).
Detach cover (2) and release nut underneath.
Tightening torque 12 42 1AZ.

Installation:
Reinstall cover (2) without fail risk of short circuiting.

Disconnect battery positive lead (3) from alternator.
Remove fuel feed line (4).







Release screws (1) on turbocharger coolant pump (2).







Picture shows the left side, the procedure for the right side is identical.
Release screws (1).
Tightening torque 12 31 1AZ.







Remove alternator (1) together with bracket (2) in direction of travel.







Note:
Check stored fault message.
Reassemble the vehicle.
Delete fault memory.

���: