54 34 442 Replacing Angle-of-Rotation Sensor on Main Bearing

54 34 442 Replacing angle-of- rotation sensor on main bearing







Open convertible top compartment lid until all hydraulic cylinders are completely extended.
Support soft top compartment lid in service position







Detach cable strap.

Installation note:
Replace faulty cable straps.

Disconnect plug connection (1).
Release screw (2).
Tightening torque 54 34 03AZ.
Remove angle-of-rotation sensor (3).







Teach-in soft top:
1. Close soft top.
2. Only in vehicles built before 09/2011: Briefly release the lock button (less than 5 seconds).
3. Operate closing button for 30 seconds (until LED flashes - LED flashes to indicate that the teach-in procedure is complete)
4. Release closing button.

�c�
: