Wiper Motor: Service and Repair
61 61 270 Removing And Installing Or Replacing Console For Windscreen Washer System Complete With Motor
IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESP protection).
IMPORTANT:
Before installing the wiper arms, allow wiper motor to run into rest position.
Emergency operation - danger of injury.
Disconnect battery cable
Disconnect both negative battery cables for F03.
Necessary preliminary work:
- Remove cowl panel cover
- Remove left/rear suspension cross-brace for F01/F02/F03/F12/F13
Release screws (1).
Tightening torque 61 61 1AZ.
Remove console for windscreen wiper system (2) in direction of arrow and disconnect plug connection (3).
Installation note:
Vacuum line (1) must not be trapped by windscreen washer system (2).
Contact with vacuum line (1) is only permitted at the positions (A/D/C) specifically designed for this purpose.
NOTE: As of 09/2009, an additional holder (1) is installed for the vacuum line (2).
Installation note:
Make sure the vacuum line (2) is correctly seated in the holder (1).
IMPORTANT: After installing, check freedom of movement between wiper kinematics and vacuum line.