51 16 366 Removing and Installing Right Glovebox With Housing

51 16 366 Removing and installing right glove box with housing







When working on trim panel components, make sure that the sensitive surfaces are not scratched or damaged.







Necessary preliminary work:
- Remove instrument panel trim, bottom left
- Remove side panel on dashboard







Release side (1) and lower screws (2) and (3).
Tightening torque 51 16 16AZ







Open glove box cover (3) if necessary.
Release upper screws (1) on glove box (2).
Tightening torque 51 16 16AZ.
Pull glove box (2) down at a slant until glove box (2) disengages.

Installation note:
Glove box (2) must engage noticeably when it is slid into place.







Disconnect plug connections (1) on damper (3) and glove box light (2).
Slip out glove box and set aside.

f D�E D: