Sunroof / Moonroof: Adjustments

54 10 004 Adjusting glass tilt sunroof cover

Special tools required:







Necessary preliminary tasks:
- Remove front cover
- Fully close glass tilt sunroof
- Check glass tilt sunroof for correct setting

Only for distance setting:
- Remove headlining
If the glass tilt sunroof is outside the setting tolerances, adjust as follows:







Height adjustment:
Carry out the following step in succession on one side first and then the other (left, right or vice versa):
- Slacken Torx screw (1) on left and right until glass tilt sunroof cover (2) can just still be moved
- Move glass tilt sunroof cover as required
- Make sure all screws are tightened down.
- Tightening torque 54 10 01AZ. 00 00 Excerpt From Company Standard BMW GS 90003-2
- Repeat worksteps on other side







Check height:
Check height of glass tilt sunroof cover (1) in relation to body (2) with special tool 00 9 315.
Press glass tilt sunroof cover (1) at front and rear upwards or downwards until the ideal position is reached.

Height:
- Front - glass tilt sunroof cover flush to 2 mm deeper
- Rear - glass tilt sunroof cover flush to 2 mm higher
Check function and adjustment.







Distance setting:
- Slacken Torx screw (1) until glass tilt sunroof cover (2) can just still be moved
- Move glass tilt sunroof cover as required
- Make sure all screws are tightened down.
- Tightening torque 54 10 01AZ. 00 00 Excerpt From Company Standard BMW GS 90003-2







Check distance:
Compare distance (A) of glass tilt sunroof cover to body with special tool 00 9 341.
Slide special tool 00 9 341between gasket and insert. It must be possible to slide the card against the same level of resistance.
Slide glass tilt sunroof cover towards front or rear until the ideal position is reached.