Securing Engine In Installation Position

11 00 670 Securing engine in installation position (N63)





Special tools required:
^ 00 6 000
^ 00 6 002
^ 00 6 004
^ 00 6 010
^ 00 6 050
^ 11 0 000





Warning!
High-voltage system - danger to life!





Warning!
The following points must be strictly observed prior to starting work:
^ Disconnect high-voltage system from power
^ Observe safety instructions for handling with hybrid cars





Warning!
Danger of injury!
Observe following instructions relating to special tool:
1. Prior to each use, check the special tools for defects, modifications and operational reliability.
2. Damaged/modified special tools must not be used!
3. No changes or modifications may be made to the special tools!
4. Keep special tools dry, clean and free of grease.





Important!
Before lifting the engine, check the lifting lugs for damage (cracks) and to ensure they are seated securely.





Note:
^ Numbering system for special tools has been re-encoded.





Important!
Special tool 00 6 000 must not be fitted when transverse member (1) is installed!





Necessary preliminary tasks:
^ Secure engine compartment lid in service position
^ Remove panel for engine compartment lid at side
^ Remove left intake silencer housing
^ Remove underbody protection at front and rear
^ Remove stiffening plate (four-wheel drive only)





Assemble transverse member 00 6 000 with special tools 00 6 002 00 6 004, 00 6 010, 00 6 050.





Note:
Contact points (1) for special tool 00 6 050 are pictured.





Important!
Risk of damage!
Position transverse member 00 6 000 with a 2nd person helping on contact points (1).

Secure special tool 11 0 000 to spindle 00 6 002.

Attach suitable chains to special tool 11 0 000 and suspend from both engine suspension lugs.





Important!
Avoid a change of engine position in the transverse or longitudinal direction.
Always make sure there is sufficient clearance between the engine (or its attachment parts) and the body.





Warning!
Danger of injury!
Tighten down all screws and nuts on transverse member 00 6 000.





Release screws (1).

Tightening torque 22 11 1AZ.

Note:
(Four-wheel drive only)

Remove vibration absorber on left front axle support.

Raise engine approx. 10 mm with transverse member.

�P� :