Removing and Installing/Replacing Upper Oil Sump Section

11 13 010 - Removing and installing/replacing upper oil sump section (N63)





Special tools required:
- 11 9 240 11 9 240 Oil Filter Wrench





Necessary preliminary tasks:
- Drain off engine oil
- Secure engine in installation position Securing Engine In Installation Position
- Lower front axle
- Remove lower oil sump section Removing and Installing/Replacing Lower Oil Sump Section
- Detach plug from oil pressure switch
- Unclip wiring harness on oil sump





Remove oil filter cover with oil filter (1) with special tool 11 9 240.
Tightening torque: 11 42 1AZ. Mechanical Specifications





Release bolt (1).
Remove oil lines (2) from oil filter housing.
Release holders of supply/return lines on oil sump





Release screws (2).
Tightening torque: 11 41 1AZ. Mechanical Specifications





Release bolts in area of line (1).

Tightening torque 11 13 2AZ .
Release bolts (2) on transmission side 24 00 1AZ 24 00 Transmission in General.
Remove upper oil sump section (3).

Installation:
Free sealing faces of seal debris and clean.
Replace seal.
Modify oil pressure switch if replacing oil sump.





Assemble engine.