Instruments - All Gauges And Displays In Cluster Inoperative
SI B62 01 13Instruments
January 2013
Technical Service
SUBJECT
All Gauges and Displays in Instrument Cluster Inoperative
MODEL
F30
Produced from SOP with option 6WA (Instrument cluster with enhanced functions)
SITUATION
All gauges and displays in the instrument cluster are inoperative, including the following:
^ Speedometer
^ Revolution counter
^ Fuel gauge
^ Engine oil temperature
^ No check control messages displayed
^ No board computer information displayed
Note:
A power cycle does NOT rectify the issue.
CAUSE
Software error in the instrument cluster
CORRECTION
Do not replace parts for this issue.
1. Perform a vehicle test using the latest ISTA (Integrated Service Technical Application) diagnostic software. Complete all test modules related to the instrument cluster.
Note:
When the ISTA system message displays: Battery voltage only "XX.XX" V. Please connect charger. Please note the displayed battery voltage reading in the repair order comments section. This documentation is not necessary when part of an approved Technical Service repair procedure; the battery charger is required to be attached before performing the Vehicle Test.
2. Reprogram the vehicle using ISTA/P 2.48.2 or later.
New integration level: F020-12-11-504 or higher
Note that ISTA/P will automatically reprogram and code all programmable control modules that do not have the latest software.
For information on programming and coding with ISTA/P, refer to CenterNet / Aftersales Portal / Service / Workshop Technology / Vehicle Programming.
WARRANTY INFORMATION
Disclaimer