Instrument Panel (IP) - Multifunction Switch Assembly Replacement
INSTRUMENT PANEL (I/P) MULTIFUNCTION SWITCH ASSEMBLY REPLACEMENTREMOVAL PROCEDURE
1. Remove the front floor console.
2. Remove the I/P accessory trim plate.
3. Remove the bolts from the switch assembly.
4. Remove the electrical connectors from the switch assembly.
5. Remove the switch assembly.
INSTALLATION PROCEDURE
1. Install the electrical connections to the switch assembly.
2. Install the bolts to the switch assembly of the rear object alarm module.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the bolts to 2 N.m (18 lb in)
3. Install the I/P accessory trim plate.
4. Install the front floor console.