Instrument Panel Cluster (IPC) - Trim Plate Bezel Replacement

Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster (Rendezvous)

Removal Procedure

1. Remove the knee bolster panel. Refer to Knee Bolster Replacement (Service and Repair) .




2. Remove the driver information center (DIC) switch from the trim plate bezel.
3. Loosen the steering column bracket. Lower the steering column.
4. Remove the trim plate bezel from the instrument panel cluster.



Installation Procedure





1. Install the trim plate bezel. Press the bezel into place until seated.

Notice: Refer to Fastener Notice in Cautions and Notices.

2. Tighten the steering column bracket nuts.

Tighten the nuts to 24 N.m (18 lb ft).

3. Install the DIC switch to the trim plate bezel.
4. Install the knee bolster panel. Refer to Knee Bolster Replacement (Service and Repair) .