Instrument Panel Cluster (IPC) - Replacement

INSTRUMENT PANEL CLUSTER (IPC) REPLACEMENT

REMOVAL PROCEDURE
1. Remove the instrument panel (I/P) cluster trim plate bezel.

IMPORTANT: Turn the ignition switch to the OFF position before you remove the instrument panel cluster.




2. Remove the screws from the I/P cluster.
3. Disconnect the electrical connectors from the I/P cluster.
4. Remove the I/P cluster.

INSTALLATION PROCEDURE
1. Connect the electrical connectors to the I/P cluster.
2. Install the I/P cluster.




3. Install the screws to the I/P cluster.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the screws to 2 N.m (18 lb in).

4. Install the I/P cluster trim plate bezel.
5. Calibrate the electronic compass.