Body - Revised Liftgate Lock Cylinder Replacement
Bulletin No.: 06-08-66-001Date: February 14, 2006
SERVICE MANUAL UPDATE
Subject:
Revised Liftgate Lock Cylinder Replacement
Models:
2004-2006 Buick Rainier Models
2002-2006 Chevrolet TrailBlazer Models
2002-2006 GMC Envoy Models
2004 Oldsmobile Bravada
2005-2006 Saab 9-7X
This bulletin is being issued to revise the Lock Cylinder Replacement - Liftgate procedure in the Body Rear End sub-section of the Service Manual. Please replace the current information in the Service Manual with the following information.
The following information has been updated within SI. If you are using a paper version of this Service Manual, please make a reference to this bulletin on the affected page.
When replacing the liftgate lock cylinder, removal of the rear window wiper motor, if equipped, is required.
Lock Cylinder Replacement - Liftgate
Removal Procedure
1. Remove the rear wiper motor. Refer to Wiper Motor Replacement - Rear.
2. Remove the lock rod from the lock cylinder.
3. Remove the C clip from the groove in the lock cylinder.
4. Remove the lock cylinder from the liftgate.
Installation Procedure
1. Install the lock cylinder to the liftgate.
2. Install the C clip to the groove in the lock cylinder.
3. Install the lock rod to the lock cylinder.
4. Install the rear wiper motor. Refer to Wiper Motor Replacement - Rear.
Disclaimer