Closeout/Insulator Panel Replacement - Right
CLOSEOUT/INSULATOR PANEL REPLACEMENT - RIGHTREMOVAL PROCEDURE
1. Remove the 2 screws that retain the insulator panel to the instrument panel (IP).
2. Partially remove the insulator panel.
3. Remove the electrical connector retaining clip from the back side of the insulator panel if equipped.
4. Remove the insulator panel from the vehicle.
INSTALLATION PROCEDURE
1. Install the insulator panel to the vehicle, positioning the insulator panel to the IP.
2. Install the electrical connector retaining clip to the back side of the insulator panel if equipped.
3. Insert the insulator panel retaining tab into the cowl slot.
4. Seat the insulator panel retaining clip to the IP substrate.
5. Install the 2 insulator panel retaining screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 2.5 Nm (22 lb in).