Air Suspension Depressurization Procedure
Air Suspension Depressurization ProcedureRemoval Procedure
Caution: Refer to Sudden Release of Pressure in the Air Suspension System Caution in Service Precautions.
Notice: Depressurize the air suspension system only after the rear axle is supported and is set between D - Height and Full Jounce.
Important: Remove the air suspension system fuse before working on the rear suspension components or the rear axle. Failure to remove the air suspension system fuse could cause the calibration of the air suspension leveling sensor to change and the air suspension system not to function properly.
1. Remove the air suspension system fuse.
2. Raise and support the vehicle. Refer to Vehicle Lifting.
3. Raise and support the rear axle at the designed D-height.
4. Remove the air compressor mounting bolts from the frame and support air compressor.
5. Loosen both of the air supply line connections at the air compressor in order to depressurize the air springs.
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
Important: Check the air supply lines for deep scores or cuts. If the air supply lines are damage the lines must be replaced.
1. Tighten the air supply lines to the air compressor. Do not over tighten.
Tighten the air supply lines to the air compressor to 2.25 Nm (20 lb ft).
2. Install the air compressor to frame mounting bolts.
Tighten the air compressor mounting bolts to the frame to 25 Nm (18 lb ft).
3. Lower the vehicle.
4. Install the air suspension system fuse.
5. Start the vehicle and run for approximately 1 minute to ensure that the air suspension system is functioning properly.
6. Check the D height.