93. Engine Flywheel Installation

Engine Flywheel Installation

- Tools Required
- J 3660-A Torque Angle Meter





1. Install the flywheel.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install new flywheel bolts.
2.1. Tighten the new flywheel bolts to 50 Nm (37 lb ft) + 45 degrees.
2.2. Use J 3666A to tighten the flywheel bolts an additional 50 degrees.