Tail Lamp Replacement

TAIL LAMP REPLACEMENT

REMOVAL PROCEDURE




1. Remove the 2 screws that retain the tail lamp assembly to the body.
2. Pull the assembly directly rearward in order to release the 2 locking pins.
3. Disconnect the tail lamp electrical connector.
4. Remove the lamp assembly from the vehicle.
5. Remove the tail lamp circuit board.

INSTALLATION PROCEDURE




1. Install the tail lamp circuit board. Refer to Tail Lamp Circuit Board Replacement .
2. Connect the tail lamp electrical connector.
3. Push the tail lamp assembly directly forward in order to seat the 2 locking pins.
4. Install the 2 tail lamp assembly retaining screws.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the screws to 1.9 N.m (17 lb in).