Window Adjustment - Endgate Cross Car

Window Adjustment - Endgate Cross Car

Adjustment Procedure




1. Lower the end gate window approximately halfway down.
2. Swing the end gate open.
3. Remove the end gate trim panel.
4. Loosen the window attachment clip bolts (1).
5. Adjust the cross car position of the end gate window by turning the adjustment cam screw (2).
Turn the adjustment cam screws to center the window to the opening with the rear roof applique.

Notice: Refer to Fastener Notice in Service Precautions.

6. Tighten the window attachment clip bolts (1).

Tighten the window attachment clip bolts to 10 N.m (89 lb in).

7. Install the end gate window sealing strip to the end gate flanges.
8. Install the end gate trim panel.