Radio, Stereo, and Compact Disc: Service and Repair

VIDEO DISPLAY REPLACEMENT

REMOVAL PROCEDURE

IMPORTANT: Do not attempt to service the video display assembly components.




The video display is serviced only as an assembly.
1. Turn the ignition switch to the OFF position.
2. Using a plastic flat bladed tool, carefully remove the bolt cover bezel.




3. Fully loosen the two rear retaining bolts. The bolts will remain attached to the video assembly.
4. In order to expose the two front retaining bolts, adjust the video display screen to a full open position.
5. Fully loosen the front retaining bolts. The bolts will remain attached to the video assembly.
6. Close the video display screen.
7. Slowly lower the front of the video assembly to release the retaining fastener (3).
8. Support the video assembly and disconnect the electrical connector (2).
9. Adjust the video assembly in order to release the T-hook (1) from the video player bracket.
10. Remove the video assembly from the vehicle.

INSTALLATION PROCEDURE

IMPORTANT: Ensure the lock washers are fully seated, completely exposing the bolt threads.




1. Install the video assembly to the vehicle.
2. Lift the and adjust the video assembly in order to install the T-hook (1) to the video player bracket. Ensure the T-hook is fully seated to the bracket.
3. Support the front of the video assembly and connect the video assembly electrical connector (2).
4. Align the retaining fastener (3) to the corresponding hole in the video player bracket.
5. Raise the front of the video assembly to install the retaining fastener (3).
6. Partially install the rear retaining bolts.
7. Adjust the video display screen to a full open position.
8. Partially install the front retaining bolts.

NOTE: Refer to Fastener Notice in Service Precautions.

9. Fully seat the retaining bolts.

Tighten
Tighten the bolts to 9 N.m (80 lb in).

10. Verify the video display for proper operation.
11. Close the video display screen.
12. Install the bolt cover bezel.