Door Mirror Actuator Replacement

This article has been updated with TSB No: 03-08-64-033.

MIRROR ACTUATOR REPLACEMENT






1. Rotate the mirror into the upward and outboard position.






2. Position your fingers flat and insert them underneath the raised corner. This will ensure that more surface of the mirror is used when removing the glass.
3. Slowly but firmly lift the glass and backing plate from the actuator.
4. Remove the wire harness from the glass if equipped with heated mirror and turn signal.
5. Remove the glass.
6. Remove the three torque head screws from the actuator.
7. Remove the actuator.
8. Remove the wire harness from the actuator.
9. Install the wire harness to the new actuator.
10. Install the new actuator.
11. Install the three torque head screws.

TIGHTEN
Torque head screws to 10 Nm (89 lb. in.).

12. Install the wire harness if equipped with heated mirror and turn signal.
13. Line up the mirror back with the actuator. Press firmly in the center of the glass using the palm of your hand. The mirror and backing plate will snap onto the actuator.
14. Make sure the mirror is locked in by lightly pulling on the mirror glass. Check the operation of the mirror and clean the glass.