Armrest Replacement - Front Seat
ARMREST REPLACEMENT - FRONT SEATREMOVAL PROCEDURE
1. Remove the armrest bolt trim cap using a small flat-bladed tool.
2. Remove the bolt from the armrest.
3. Remove the armrest from the front bucket seat.
INSTALLATION PROCEDURE
1. Position the bolt into the mounting point of the armrest.
2. Position the armrest to the front bucker seat.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Tighten the armrest mounting bolt.
Tighten
Tighten the armrest mounting bolt to 4.5 N.m (40 lb in).
IMPORTANT: Rotate the armrest bolt trim cap to a new position to allow the retainer on the cap to seat properly.
4. install the armrest bolt trim cap pressing into place until fully seated.
5. Inspect the armrest for proper movement.