Correction

Important:
The new tilt stop bumper can be obtained from the Warranty Parts Center.

DO NOT REPLACE THE STEERING COLUMN. A new service steering column tilt stop bumper has been released to correct this condition. The increased length of this new bumper will reduce the travel and eliminate the feel that the steering wheel doesn't lock in the top tilt position. Replace the tilt stop bumper using the procedure listed below.

1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.

2. Disable the SIR system.

3. Remove the knee bolster trim panel.

4. Remove the inflatable restraint steering wheel module using J 44298.

5. Remove the steering wheel nut and steering wheel using J 1859-A and J 42578.

6. Remove the tilt lever close out plate.

7. Remove the screws and the lower steering column trim cover.

8. Remove the retaining screw from the upper steering column trim cover.





9. Lift the upper trim cover in order to gain access to the lock cylinder access hole (1).





10. Insert the Snap-On A173A bent-tip awl (1), or equivalent, with a 2.5 mm (3/32 in) tip and 20 mm (3/4 in) in length, into the access hole of the ignition lock cylinder.

11. Turn the ignition lock cylinder to START.

12. Use the bent tip in order to push down on the ignition lock cylinder retainer.

13. Release the ignition lock cylinder to the RUN position.





14. Remove the ignition lock cylinder from the lock cylinder case.

15. Remove the upper steering column cover.





16. Place a small cloth between the steering column upper and lower tilt heads as shown. This will prevent the stop bumpers from falling into the steering column when they are removed.

17. Remove the two stop bumpers from the steering column lower tilt head.





18. Install the new stop bumper into the steering column lower tilt head.

19. Install the upper steering column cover.

20. Install the ignition lock cylinder into the lock cylinder case.

21. Install the retaining screw to the upper steering column trim cover.

22. Install the lower steering column trim cover and screws.

23. Install the tilt lever close out plate.

24. Install the steering wheel and nut.

Tighten

Tighten the nut to 41 Nm (30 lb-ft).

25. Install the inflatable restraint steering wheel module.

26. Install the knee bolster trim panel.

27. Enable the SIR system.

28. Connect the battery negative cable.