Onstar Microphone Replacement
ONSTAR MICROPHONE REPLACEMENTREMOVAL PROCEDURE
1. Remove the overhead console door (1).
2. Reach your hand through the access opening and disconnect the microphone connector (2) from the jumper harness.
3. Unsnap the microphone bracket from the overhead console.
4. Disconnect the microphone 2-way connector from the mating 2-way connector.
INSTALLATION PROCEDURE
1. Reach your hand through the access opening and install the microphone to the overhead console at the left rear corner of the overhead console.
2. Snap the microphone bracket to the overhead console.
3. Connect the microphone connector (2) to the mating 2-way connector.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the overhead console door (1).
Install the screws securing the overhead console door.
Tighten
Tighten the screws to 10 N.m (89 lb in).