Linear Shift
Linear Shift Assembly ReplacementRemoval Procedure
1. Disable the SIR System.
5. Remove the steering column trim covers.
6. Remove the automatic transaxle selector cable retainer (3) and cable (2) from the steering column control lever (1).
7. Remove the shift lever.
8. Remove the retaining screws (1) from the linear shift assembly.
9. Twist the linear shift park lock cable to remove the cable (2) from the lock housing (1).
10. Remove the electrical connector (3).
11. Remove the liner shift assembly.
Installation Procedure
1. Important: If the lock cylinder does not rotate to off/lock position, adjust the linear shift park lock cable.
Install the linear shift assembly.
2. Notice: Refer to Fastener Notice in Service Precautions.
Install the retaining screws (1).
Tighten the screws to 10 Nm (89 inch lbs.).
3. Connect the electrical connector (3).
4. Twist the linear shift park lock cable to install the cable (2) into the lock housing (1).
5. Install the shift lever.
6. Install the automatic transaxle selector cable (2) and retainer (3) to the steering column control lever (1).
7. Install the steering column trim covers.
8. Enable the SIR system.