Rear Suspension

Tie Rod Replacement (Front Wheel Drive)

Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. If the vehicle is equipped with automatic level control, perform the following steps:
1. Disconnect the automatic level control sensor electrical connector.

2. Important: Do NOT disconnect the automatic level control sensor link from the sensor arm.

Disconnect the height sensor link from the rear axle tie rod.





3. Remove the rear axle tie rod bolts.
4. Remove the rear axle tie rod from the vehicle.

Installation Procedure





1. Install the rear axle tie rod to the vehicle.

2. Notice: Refer to Fastener Notice in Service Precautions.

Install the rear axle tie rod bolts and nuts.
Tighten the rear axle tie rod bolts to 125 Nm (92 ft. lbs.).

3. Notice: When you are servicing the automatic level control sensor link, ensure that the sensor link and the sensor arm are not damaged. Ensure the sensor arm and the sensor link are properly oriented. Improper orientation of the sensor arm and the sensor link may cause damage to the automatic level control system or the vehicle.

If the vehicle is equipped with automatic level control, perform the following steps:
1. Install the height sensor link to the rear axle tie rod.
2. Connect the automatic level control sensor electrical connector.

4. Lower the vehicle.