Blower Motor - Auxiliary (Rear Auxillary)

BLOWER MOTOR REPLACEMENT - AUXILIARY (REAR AUXILIARY)

REMOVAL PROCEDURE
1. Remove the right rear quarter trim panel.




2. Remove the retaining bolts (5) from the HVAC module-auxiliary (1).
3. Remove the retaining nuts (4) from the HVAC module-auxiliary (1) under the vehicle.




4. Disconnect the electrical connectors (3,4).
5. Remove the blower motor screws.
6. Remove the blower motor (1) from the HVAC module-auxiliary (2).

INSTALLATION PROCEDURE




1. Install the blower motor-auxiliary (1) to the HVAC module-auxiliary (2).
2. Install the blower motor-auxiliary screws.

Tighten the screws to 2 N.m (18 lb in).

NOTE: Refer to Fastener Notice in Service Precautions.

3. Connect the electrical connectors (3,4).




4. Install the retaining bolts (5) to the HVAC module-auxiliary.
5. Tighten the HVAC module-auxiliary retaining bolts (5).

Tighten the bolts to 10 N.m (88 lb in).

NOTE: Refer to Fastener Notice in Service Precautions.

6. Install the retaining nuts (4) to the HVAC module-auxiliary (1) under the vehicle.

Tighten the nuts to 10 N.m (88 lb in).

7. Install the right rear quarter trim.