Crankshaft, Engine

Crankshaft End Play 0.04 - 0.2 mm (0.0015 - 0.0078 in)

Crankshaft Main Journal Diameter
Production 64.992 - 65.008 mm (2.558 - 2.559 in)
Service 64.992 mm (2.558 in)

Crankshaft Main Journal Out-of-Round
Production 0.003 mm (0.000118 in)
Service 0.008 mm (0.0003 in)

Crankshaft Main Journal Taper
Production 0.01 mm (0.0004 in)
Service 0.02 mm (0.00078 in)

Crankshaft Rear Flange Runout 0.05 mm (0.002 in)

Crankshaft Reluctor Ring Runout 0.7 mm (0.028 in)
(Measured 1.0 mm (0.04 inch) Below Tooth Diameter)

Crankshaft Thrust Surface
Production 26.14 - 26.22 mm (1.029 - 1.0315 in)
Service 26.22 mm (1.0315 in)

Crankshaft Thrust Surface Runout 0.025 mm (0.001 in)









Crankshaft Bearing Cap
M10 Bolt
First Pass in Sequence 20 Nm (15 ft. lbs.)
Final Pass in Sequence 80 degrees

M10 Studs
First Pass in Sequence 20 Nm (15 ft. lbs.)
Final Pass in Sequence 51 degrees

M8 Bolt 25 Nm (18 ft. lbs.)

Crankshaft Main Bearing
Bore Diameter 69.871 - 69.889 mm (2.75 - 2.751 in)
Bore Out of Round 0.006 mm (0.0002 in)

Crankshaft Main Bearing Clearance
Production 0.02 - 0.052 mm (0.0008 - 0.0021 in)
Service 0.02 - 0.065 mm (0.0008 - 0.0025 in)