Instrument Panel (IP) - Accessory Trim Plate Replacement

Trim Plate Replacement - Instrument Panel (I/P) Accessory (Aztek)

Removal Procedure

1. Position the floor shifter in the Drive position.
2. Remove the front floor console. Refer to Trim Plate Replacement - Front Floor Console (Aztek) (Trim Plate Replacement - Front Floor Console)Trim Plate Replacement - Front Floor Console (Rendezvous) (Trim Plate Replacement - Front Floor Console) .
3. Remove 2 screws from the lower trim plate.




4. Remove the instrument panel (I/P) accessory trim plate by releasing the retainers.



Installation Procedure





1. Align the retainers on the I/P accessory trim plate to the slots in the I/P.
2. Install the retainers into the slots until the retainers are fully seated.

Notice: Refer to Fastener Notice in Cautions and Notices.

3. Install the 2 screws to the lower trim plate.

Tighten the screws to 2 N.m (18 lb in).

4. Install the front floor console. Refer to Trim Plate Replacement - Front Floor Console (Aztek) (Trim Plate Replacement - Front Floor Console)Trim Plate Replacement - Front Floor Console (Rendezvous) (Trim Plate Replacement - Front Floor Console) .