Memory Seat Control Module Replacement

MEMORY SEAT CONTROL MODULE REPLACEMENT

REMOVAL PROCEDURE




1. Disable the SIR. Refer to SIR Disabling and Enabling Zone 7 in Restraint Systems.

CAUTION: Refer to SIR Caution in Service Precautions.

2. Adjust the front seat assembly up and forward in order to access the fasteners (1) at the rear of the front seat cushion assembly.
3. Remove the fasteners.




4. Adjust the front seat assembly to the rear of the vehicle.
5. Angle the front seat cushion (1) up, in order to access the assembly fasteners (2).
6. Remove the fasteners.
7. Lift the front seat cushion assembly (1) away from the seat riser.




8. Disconnect the electrical connector.
9. Using a flat-bladed tool, release the module from the bracket.
10. Remove the memory seat module from the seat frame.

INSTALLATION PROCEDURE




1. Install the memory seat module to the seat frame.
2. Press the module into the bracket until the module is firmly seated.
3. Connect the electrical connector to the memory seat module.




4. Install the seat cushion assembly (1) to the seat riser.
5. Install the fasteners (2) to the seat cushion assembly (1).




6. Adjust the front seat assembly up and forward in order to access the fasteners (1).
7. Install the fasteners (1) to the seat cushion assembly.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the fasteners to 9 N.m (80 lb in).

8. Angle the front seat cushion up, in order to access the assembly fasteners.

Tighten the fasteners to 9 N.m (80 lb in).

9. Enable the SIR. Refer to SIR Disabling and Enabling Zone 7 in Restraint Systems.
10. Calibrate the seat. Refer to Memory Seat Calibration Procedure.