Armrest Replacement - Front Seat

ARMREST REPLACEMENT - FRONT SEAT

REMOVAL PROCEDURE




1. Remove the armrest bolt trim cap using a small flat-bladed tool.




2. Remove the bolt from the armrest.
3. Remove the armrest from the front bucket seat.

INSTALLATION PROCEDURE




1. Position the bolt into the mounting point of the armrest.




2. Position the armrest to the front bucker seat.
3. Tighten the armrest mounting bolt.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the armrest mounting bolt to 4.5 N.m (40 lb in).




4. install the armrest bolt trim cap pressing into place until fully seated.

IMPORTANT: Rotate the armrest bolt trim cap to a new position to allow the retainer on the cap to seat properly.

5. Inspect the armrest for proper movement.