Disc Brake Component Specifications

This information has been updated by TSB Manual Update Bulletin No. 05-05-23-003 dated June 17, 2005.


Front Brakes
Rotor Thickness - NEW 32.2�mm 1.27in
Rotor Discard Thickness 30.7�mm 1.21�in
Rotor Maximum Allowable Assembled Lateral Runout 0.06�mm 0.002�in
Rotor Maximum Allowable Scoring 1.50�mm 0.059�in
Rotor Maximum Allowable Thickness Variation 0.025�mm 0.001�in
Rotor Minimum Allowable Thickness After Refinish 31.08�mm 1.22�in

Rear Brakes
Rotor Thickness - NEW 12.0�mm 0.472�in
Rotor Discard Thickness* 10.5�mm 0.413�in
Rotor Maximum Allowable Assembled Lateral Runout 0.06�mm 0.002�in
Rotor Maximum Allowable Scoring 1.50�mm 0.059�in
Rotor Maximum Allowable Thickness Variation 0.025�mm 0.001�in
Rotor Minimum Allowable Thickness After Refinish 10.8�mm 0.425�in

All brake rotors have a discard dimension cast into them. Replace any rotor that does not
meet this specification. After refinishing the rotor, replace any rotor that does not meet
the minimum thickness specifications.