Power Window Motor: Service and Repair

DOOR MODULE REPLACEMENT - FRONT

REMOVAL PROCEDURE
1. Remove the door trim panel.
2. Remove the water deflector.
3. Remove the front door speaker.
4. Disconnect the door wiring harness from the body harness.
5. Disconnect the sash from the glass by squeezing the tabs on both of the glass attachment clips at the same time. With the tabs pressed down, slide the sash in the direction of the snap tabs until the sash clips clear the glass attachment clips.




6. Slide the glass (1) full up and tape in place to the door window frame (2).




7. Remove the 3 door to latch (2) screws.
8. Remove the outside handle from the door, including the disconnecting rod.




9. Pull the door harness through hinge face into door cavity and remove the door module (6 screws total).

INSTALLATION PROCEDURE




1. Position the front door hardware module to the front door.
2. Align the modular locator pin (1) into the 4-way locating hole (2) in the door structure.
3. Install the front door module screws.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the screws, as shown, to 10 N.m (89 lb in).




4. Install the 3 (1) door to latch (2) screws.

Tighten the screws, in sequence as shown, to 10 N.m (89 lb in).

5. Install the outside handle including the rod connect.
6. Remove the tape on the glass and install the glass to the door module sash.
7. Load the door wiring harness through the hinge face and attach to the body harness.
8. Install the front door water deflector.
9. Install the front door speaker.
10. Install the door trim panel.