Rack and Pinion Outer Tie Rod End Replacement

Rack and Pinion Outer Tie Rod End Replacement

Tools Required
^ J24319-B Steering Linkage and Tie Rod Puller

Removal Procedure
1. Raise and support the vehicle.
2. Remove the tire and wheel.





3. Remove the outer tie rod retaining nut.





4. Disconnect the outer tie rod from the steering knuckle using J24319-B.

Notice: Do not attempt to disconnect a steering linkage joint by driving a wedge between the joint and the attached part. Seal damage may result which will cause premature failure of the joint.






5. Loosen the jam nut (1) and remove the outer tie rod (2) from the inner tie rod (3). Do not reuse the jam nut.
6. Inspect the shaft for bent or damaged threads.
7. Clean the tapered surface of the steering knuckle.

Installation Procedure





1. Lubricate the inner tie rod (3) threads with a suitable chassis lubricant before installing the outer tie rod (2).
2. Install the new jam nut (1) to the outer tie rod (2).
3. Install the outer tie rod (2) to the inner tie rod (3).





4. Install the outer tie rod to the steering knuckle.

5. Install the new outer tie rod retaining nut.
Tighten the outer tie rod retaining nut to 60 Nm (44 ft. lbs.).

Notice: Refer to Fastener Notice in Service Precautions.

6. Install the tire and wheel.
7. Lower the vehicle.
8. Adjust the front toe.