HVAC Control Module - Auxiliary

HVAC CONTROL MODULE REPLACEMENT - AUXILIARY

REMOVAL PROCEDURE




1. Using a flat bladed tool, carefully pry out on the top of the HVAC control-auxiliary.
2. Remove the HVAC control-auxiliary from the center console/seat.




3. Disconnect the electrical connector.
4. Remove the rear HVAC control-auxiliary from the vehicle.

INSTALLATION PROCEDURE




1. Connect the rear HVAC control-auxiliary electrical connector.




2. Install the HVAC control-auxiliary in the console bottom first.
3. Push in at the top of the HVAC control-auxiliary in order to engage the HVAC control-auxiliary in the console/seat.
4. Refer to Control Module References for programming and setup information. Programming and Relearning