Vehicle Rollover Sensor

INFLATABLE RESTRAINT VEHICLE ROLLOVER SENSOR REPLACEMENT

REMOVAL PROCEDURE
1. Disable the SIR system. Refer to SIR Disabling and Enabling.

CAUTION: Refer to SIR Caution.




2. Fold back the rear carpet in order to gain access to the sensor. Refer to Carpet Replacement - Rear (TrailBlazer, Envoy, Rainier) Carpet Replacement - Rear (TrailBlazer EXT, Envoy XL) in Interior Trim.
3. Disconnect the electrical connector.
4. Remove the nuts securing the rollover sensor to the floor panel.

INSTALLATION PROCEDURE




1. Install the nuts securing the rollover sensor to the floor panel.

Tighten the screws to 10 N.m (88 lb in).

NOTE: Refer to Fastener Notice in Service Precautions.

2. Connect the electrical connectors.
3. Install the rear carpet.
4. Enable the SIR system. Refer to SIR Disabling and Enabling.