Cowl Moulding / Trim: Service and Repair

Air Inlet Grille Panel Replacement

Tools Required

J 38778 Door Trim Pad and Garnish Clip Remover


Removal Procedure





1. Open the hood.
2. Remove the windshield wiper arms. Refer to Wiper Arm Replacement in Wiper Washer Systems.
3. Reposition the windshield wiper washer hose from the air inlet grille.




4. Remove the push-in retainers from the air inlet grille, using the J 38778 .




5. Remove the air inlet grille extensions from the air inlet grille at the windshield.
Pull up and out in order to release the retainers on the air inlet grille extensions.




6. Remove the air inlet grille from the vehicle.



Installation Procedure






Important: Inspect the position of the air inlet seal to the windshield. If not seated properly, reposition the air inlet grille as required.


1. Position the air inlet grille to the vehicle.




2. Install the air inlet grille extensions to the air inlet grille and the windshield, pressing into place until fully seated.




3. Install the push-in retainers to the air inlet grille.




4. Reposition the windshield wiper washer hose to the air inlet grille.
5. Install the windshield wiper arms. Refer to Wiper Arm Replacement in Wiper Washer Systems.
6. Close the hood.