Fog/Driving Lamp: Service and Repair

FOG LAMP REPLACEMENT - FRONT

REMOVAL PROCEDURE




1. Raise and support the vehicle. Refer to Vehicle Lifting.

CAUTION: Refer to Halogen Bulb Caution in Service Precautions.

2. Remove the fog lamp socket from the fog lamp by rotating counterclockwise.
3. Disconnect the fog lamp electrical connector from the fog lamp socket, if required.




4. Remove the fog lamp nuts (2) from the fog lamp.




5. Remove the fog lamp from the front bumper fascia.

INSTALLATION PROCEDURE




1. Position the fog lamp to the front bumper fascia.




2. Install the fog lamp nuts (2) to the fog lamp.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the fog lamp nuts to 10 N.m (89 lb in).

3. Connect the fog lamp electrical connector to the fog lamp socket, if removed.
4. Install the fog lamp socket (3) to the fog lamp by rotating clockwise.
5. Lower the vehicle.
6. Check and adjust the fog lamp aim as necessary. Refer to Fog Lamp Aiming Procedure.