Vehicle Speed Sensor: Service and Repair

Vehicle Speed Sensor (VSS) Replacement

Removal Procedure
1. Raise and support the vehicle.
2. Disconnect the electrical connector at the vehicle speed sensor.





3. Remove the retaining bolt (9) and the sensor (10).

Installation Procedure





1. Inspect the O-ring (11). If damaged, replace as necessary.





Notice: Refer to Fastener Notice in Service Precautions.

2. Install the vehicle speed sensor (10) and the retaining bolt (9).
^ Tighten the bolt to 12 Nm (106 inch lbs.).
3. Connect the electrical connector to the sensor.
4. Lower the vehicle.