Handle Replacement - Liftgate

Handle Replacement - Liftgate

Removal Procedure





1. Open the liftgate.
2. Remove the liftgate trim panel. Refer to Trim Panel Replacement - Liftgate (Service and Repair) .
3. Remove the water deflector. Refer to Water Deflector Replacement - Liftgate (Service and Repair) .
4. Remove the license plate lamp sockets by turning the sockets counterclockwise.
5. Remove the liftgate handle nuts (1, 2) from the studs inside the liftgate (3).




6. Remove the bolts (2) from the liftgate handle.
7. Remove the liftgate latch cable from the handle.
8. Remove the liftgate handle from the liftgate.
9. Remove the liftgate handle gasket and discard.



Installation Procedure





1. Install a new liftgate handle gasket (1) prior to installing the liftgate handle.




2. Install the liftgate latch cable to the liftgate handle.
3. Align the liftgate handle studs with holes in liftgate.

Notice: Refer to Fastener Notice in Cautions and Notices.

4. Install the liftgate handle retaining bolts (2).

Tighten the bolts to 10 N.m (89 lb in).





5. Install the liftgate handle retaining nuts (1, 2) to the studs.

Tighten the nuts to 10 N.m (89 lb in).

6. Install license plate lamp sockets by turning sockets clockwise.
7. Install the water deflector. Refer to Water Deflector Replacement - Liftgate (Service and Repair) .
8. Install the liftgate trim panel. Refer to Trim Panel Replacement - Liftgate (Service and Repair) .
9. Close the liftgate.