Disc Brake Hardware Replacement - Front

Disc Brake Hardware Replacement - Front
Removal Procedure

Caution: Refer to Brake Dust Caution in Service Precautions.

1. Inspect the fluid level in the brake master cylinder reservoir.
2. If the brake fluid level is midway between the maximum-full point and the minimum allowable level, then no brake fluid needs to be removed from the reservoir before proceeding. If the brake fluid level is higher than midway between the maximum-full point and the minimum allowable level, then remove brake fluid to the midway point before proceeding.
3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
4. Remove the tire and wheel.





5. Using a C-clamp installed to the center of the outer disc brake pad and the back of the caliper, slowly compress the caliper piston into its bore just enough to remove the caliper from the mounting bracket (5).

6. Notice: Refer to Support the Brake Caliper While Flex Hose is Connected Notice in Service Precautions.

Remove the disc brake caliper bolts (1).
7. Remove the disc brake caliper (3) from the mounting bracket.
8. Remove the disc brake pads (6) and (8) from the disc brake caliper bracket.
9. Remove the disc brake pad retainers from the disc brake caliper bracket.
10. Remove the disc brake caliper bolt boots (4) from the caliper mounting bracket.
11. Lightly wire brush all brake pad contact areas in order to remove any corrosion.

Installation Procedure





1. Lubricate with High Temp Silicone and install the caliper bolt boots (4) to the disc brake caliper mounting bracket (5).
2. Lubricate and Install the disc brake pad retainers to the disc brake caliper bracket.
3. Install the disc brake pads (6) and (8) to the disc brake caliper bracket.
4. Install the disc brake caliper (3) from the mounting bracket.

Notice: Refer to Fastener Notice in Service Precautions.

5. Lubricate and Install the disc brake caliper bolts (1).
^ Tighten the disc brake caliper bolts to 54 Nm (40 ft. lbs.).
6. Apply and release the brake pedal (3/4 stroke) as many times as necessary in order to obtain a firm brake pedal.
7. Install the tire and wheel.
9. Fill the master cylinder to the proper level. Refer to Master Cylinder Reservoir Filling.